A B C D E F G H I J K L M N O P Q R S T U V W X Y Z All
Vijayalakshmi, V. J.
- Smart System for Open Conductor Identification in LT Lines of Distribution System
Authors
1 Electrical and Electronics Engineering, SSK College of Engineering & Technology, Coimbatore-641105, IN
2 Department of Electrical and Electronics Engineering, SSK College of Engineering & Technology, Coimbatore-641105, IN
Source
Networking and Communication Engineering, Vol 4, No 3 (2012), Pagination: 178-182Abstract
The system consists of one or more transmitters and a receiver which communicate through wireless system. The transmitter detects the open phase conductor by monitoring the phaseconductor voltage. When an open phase conductor detected, the transmitter send the signal to receiver by using wireless system. The receiver decodes the signal and generates a trip signal which mayactive a breaker a ground switch or recloser causing isolation of the distribution line with open phase conductor .The system is suitable for three phase distribution lines, if perfectly isolate the fault phase alone because most of the consumer are single phase user except industrial user. It also activates the alarm on control room of electricboard and sends the SMS to authorized person or officer about the fault using GSM. In case of working of men in distribution line, It display the content in screen as "Men at work' in order to avoid to switch on the supply while working and it also never allow the power to flow on distribution line by activating the special safety switch in this system.
Keywords
Ac, Dc, GSM.- Implementation of Energy Conservation Module for Wood Fired Boiler
Authors
1 Department of EEE, KPR Institute of Engineering and Technology, Arasur, Coimbatore - 641407, IN
Source
Automation and Autonomous Systems, Vol 11, No 2 (2019), Pagination: 32-35Abstract
This paper manages the ecological effect and remedies against the burning of wood in the wood-terminated boiler. The prerequisite for basic research on burning of wood mash fills has been created since 2000.The decline of CO and NO2 from normal strategy of emanation decrease is performed with need for a few mechanical makers and as often as possible incorporates costly terminal pipe tainting decline courses of action. The epic technique which is talked about in this paper has a different emanation control module which implants oxygen into boiler for better ignition. The module focuses on the emanation decrease of wood terminated boiler utilizing a control circuit planned at reasonable expense in industry perspective.
This substance fixates on the complexities managing the peril of frustration in a natural improvement setting, related with wood as fuel in fuel-devouring machines crosswire over diverse zones.
Keywords
Combustion Efficiency, Master-Slave Configuration, Oxygen Injection, Emission Reduction.References
- Stefan Laux and Bradley Damsted, “Innovative oxygen injection for emission reduction in cement kilns”, in Cement Clinker Production with Reduced Emission,vol.59, no.6, pp.978-985, 2012
- Marius Zainea and HerveGueguen, “Modelling and Control of Building Heating using Wood Burning Boilers”, in Multi Conference on System and Control, vol.54, no.1, pp.124-257, 2014
- FethiBelkhir and Georg Freys, “Model Driven Soft Sensor for Predicting Biomass Calorific Value in Combustion Power Plants”, in Sarland University,vol.60, no.2, pp.146-167, 2013
- V.Placek and S.Vrana and B.Sulc, “I and C of a small scale biomass fired boiler setup”, Strojarstvo, vol.XIII, no.5,pp.43/1-43/4,2016
- Ch.Yin and L.A.Rosendahl and S.K.Kaer, “Grate-firing of biomass for heat and power production”, Progress in Energy and Combustion Science, vol.34,no.6,pp.725-754,2014
- W.Du and G.Shen and Y.Chen, “Comparsion of air pollutant emissions and household air quality in rural homes using improved wood and coal stoves”, Atmospheric Environment, vol.166, pp.215-233, 2017
- A.Leva and C.Maffezzoni and G.Benelli, “Validation of drum boiler models through complete dynamic test”, Control Engineering Practice, vol.7, no.1, pp.11-26, 2012
- K.J.Astrom and R.D.Bell, “Drum boiler dynamics”, Atomatica, vol.36, no.3, pp.363-378, 2009
- Maureen E.Puettmann and Michel Milota, “Life Cycle Assessment for Wood-Fired Boilers used in the Wood Products Industries”, in Forest Products,vol.23,no.3,pp.155- 160,2014
- U.Kortela and A.Marttinen, “Modelling, identification and control of a grate boiler”, in American Control Conference, vol.83, no.7, pp.544-549, 2014
- D.F.Conveney and J.K.Hicks, “Oxygen enrichment for improvements in emission control while burning waste fuel”, in Bioresource Technology, vol.52, no.5, pp.522-525, 2010 16
- Lucian LonelCioca, “Local Environmental Impact of Wood Combustion in Agro-Toursim Structures”, in University of Trento, vol.68, no.4, pp.234-238, 2016
- Michal Safara and Helena Raclavska, “Problems with Utilisation of Engineering Wood for Energy Purpose”, in Smart Energy,vol.74, no.5, pp.545-576, 2017
- P.Wrampe and H.C.Rolseth, “The Effect of Oxygen upon the Rotary Kiln’s Production and Fuel Efficiency”, Theory and Practice, IEEE Transactions Industry Applications, vol.IA- 12, no.6.Nov/Dec 2017
- SuprajaSridharan, “Carbon monoxide Risks and Implications on Maintenance-Intensive Fuel-Burning Appliances”, in Regulatory Perspective, vol.35, no.2, pp.423- 438, 2015.